The manufacturer of pipe chain conveyor teaches you how to dismantle it after it stops working?
For the ropes and mechanical equipment to be used during the inspection of the pipe chain conveyor manufacturer, the prefabricated components can be used to stop self reflection, and the professional ability can be used after meeting the requirements. When withdrawing, the operators shall obey the leadership, cooperate with each other, strictly stop the safety precautions according to the safety disclosure order, especially pay attention to the solid geographical environment of the formwork project when finding out the cable wind rope. It is also necessary for staff to detect, prohibit irrelevant employees from entering, and look at the solid geographical environment of the frame during the withdrawal process at any time. If there are tilt difficulties, inform the responsible person to stop the course content first.
The pipe chain conveyor manufacturer must select the place to install at the beginning, level the ground and keep the ground level. In that case, the requirements for the straightening of the pipe chain conveyor manufacturer are finally exceeded. The height requirement is to make sure that the upper, middle and lower parts of the multi-directional effect is just right. In addition, it is important to fix them in the concrete foundation. After the shell is installed, the screw cap of U-shaped screws shall be tightened to prevent safety accidents caused by looseness; For the installation of industrial equipment drive belt and silo, it must be adjusted and then tightened appropriately to ensure the safety factor.
After the pipe chain conveyor manufacturer carries out transportation, it shall timely liquidate the residual raw materials of the person's body. After the delivery of raw materials by customers, the residual raw materials of the human body of the belt conveyor are not cleared in time in the future. This kind of practice is not useful, because if the raw materials are sticky or wet, they will be corroded in the future, which will always be able to stick to the blade or the inner wall to hurt the application and service life of the weapon.
Before the disassembly and assembly of the pipe chain conveyor manufacturer, the person in charge of the construction site shall prepare the safety disclosure according to the withdrawal method, withdrawal order, applied equipment, mechanical equipment and the actual geographical environment of the site. The content of the safety disclosure shall be comprehensive, and the pipe chain conveyor manufacturer shall be highly utilitarian. After the safety disclosure of safety mode is compiled, the action exchange shall be stopped for all employees. In fact, the cancellation mode and cancellation order shall be taught, and the essential and important matters and actual requirements when the manufacturer of pipe chain conveyor cancels. After the safety disclosure, the person in charge of the construction site and the person in charge of the course class must sign on the written notice of the safety disclosure to clarify the post responsibilities implemented respectively.
Proper maintenance shall be carried out during the operation of the pipe chain conveyor. For example, after each standby, all raw materials in the bucket shall be removed and cleaned, and then the industrial equipment shall be stopped. During the operation, there must be no need to turn out. The negative impact of turning over will cause failure, and it is very troublesome to repair. The raw materials shall be filled evenly, and the raw materials shall not be transported smoothly from big to small, so that the stuffy vehicle may cause safety production accidents. During operation, regular maintenance shall be carried out immediately to make up for the use of lubricating grease and improve the working efficiency of pipe chain conveyor.